10 Best Halloween Mask 3D Prints (2026): Free MakerWorld Models + Filament Picks
Published by Canyang Chen
Content in this article
Halloween mask season is one of the best excuses to load up the printer, and MakerWorld has thousands of options tagged for it. We combed through the community's Masks and Helmets category and pulled ten genuinely spooky, non-licensed-character designs, skulls, oni demons, ravens, pumpkins, and masquerade pieces, that print well and look great on a shelf or a face. For each one we're linking straight to the designer's MakerWorld page and suggesting the Filazoo filament we'd reach for.
A quick note on downloads and images: the photos on each MakerWorld page belong to the designer and most are licensed for personal, non-commercial use only, so we're linking out to the real pages instead of copying their pictures here. The icon beside each entry below is our own original illustration, not a photo of the actual print. Always check the license tab on the model page before printing, especially if you plan to sell the finished mask.
Sizing tip: most wearable masks list a face-width scaling table on their MakerWorld page. Always scale X, Y, and Z uniformly so the mask keeps its proportions.
1. Pumpkin Skull Halloween Mask
Designer: Salewski3D. A full-face mask that fuses a classic jack-o-lantern face with a sinister skull structure, sharp, deep-cut detailing that reads well from across a room.
View and download on MakerWorld
Filament pick: Filazoo PLA+ - a full-face mask gets bumped and handled a lot, so PLA+'s extra toughness over standard PLA helps it survive a night out without chipping at the thin skull ridges.
2. Gothic Raven Mask (Wearable)
Designer: DTM247. A sculpted half-mask built around a raven's beak and feather detailing, more gothic costume piece than cartoon bird, and comfortable enough to wear for a full evening.
View and download on MakerWorld
Filament pick: Filazoo PLA Matte in Black - the low-gloss finish hides layer lines on the feather texture and avoids the shiny look that would fight the gothic aesthetic.
Shop Filazoo PLA Matte Filament
3. Samurai Oni Mask #02
Designer: ONI.FORGE. A traditional Japanese oni demon face, bulging eyes, exaggerated brow, and bared fangs, sculpted with the kind of depth that actually reads well straight off the printer, before any painting.
View and download on MakerWorld
Filament pick: Filazoo PLA+ Silk in Silk Red Copper - oni masks are traditionally lacquered red, and the silk sheen gets you close to that look straight off the plate, with PLA+'s added toughness for a mask that gets handled.
Shop Filazoo PLA+ Silk Filament
'4. Wendigo Deer Skull Wearable Mask
Designer: DTM247. A skeletal deer-skull mask with antlers, tall, dramatic, and one of the more advanced prints on this list given the antler geometry, but a real showstopper for a haunted-woods costume.
View and download on MakerWorld
Filament pick: Filazoo Wood PLA - the real wood-particle fill gives the skull and antlers a natural, slightly rough bone-and-branch texture that plain PLA can't replicate without painting.
Filazoo community
Join the conversation
Ask a question, share a printing tip, or tell us what worked for your project.